M.T.H. Premier Genesis Diesel Locomotive Operator's Manual download pdf (Page 12)

While the engine is programmed to start with the speed control feature activated, you can

opt to turn it off. This means the engine's speed will fall as it labors up a hill and increase

as it travels downward. It is also affected by the addition or releasing of cars while on the

run. Because the engine will run more slowly at a given throttle voltage when speed

control is on than when it is off, you should adjust the throttle to a lower power level for

operation with speed control off to avoid high-speed derailments. When speed control is

off, the volume will drop to allow for better low voltage operation.

To turn speed control on and off, put the engine in neutral, then quickly tap the

transformer's Horn button one time then quickly tap the Bell button two times, allowing

approximately ½ second to lapse between each quick button press. Two horn blasts will

indicate that the engine has made the change. Repeat the 1 horn, 2 bells code to return it

to the other condition. You will want to do this during the initial neutral upon start-up if

you ever couple this engine to another engine that is not equipped with speed control to

avoid damaging the motors in either engine. Each time you shut down the engine

completely, it will automatically turn speed control on.

Horn

Place

Engine into

Neutral

Bell Bell

Speed Control

Two Horn Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

Locking Locomotive Into A Direction

You can lock your engine into a direction (forward, neutral, or reverse) so that it will

not change directions. To do this, put the engine into the direction you want (or into

neutral to lock it into neutral), run it at a very slow crawl (as slowly as it will move

without halting), and quickly but firmly tap the Horn button once followed by three

quick taps of the Bell button, allowing approximately ½ second to lapse between each

quick button press. Two horn blasts will indicate that the engine has made the change.

The engine will not change direction (including going into neutral) until you repeat the

1 horn, 3 bells code to return the engine to its normal condition, even if the engine is

kept without power for extended periods of time.

Horn

Place

Engine into

Desired

Direction

Horn

Bell Bell Bell

Direction Lock

Two Horn Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

Premier Genesis Diesel Engine w/Proto-Sound® 3.0

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 48 49

Comments to this Manuals

No comments

M.T.H. Premier Genesis Diesel Locomotive Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Toys & accessories M.T.H. Premier Genesis Diesel Locomotive